- fixed indenting on existing code in a few places for consistency
- introduced IR_TIMER_USE_ESP32 for ifdefs within the code as per
request
- added comments explaining what's missing for irsend support on ESP32
- IRrecvDemo.ino gets a warning before and after interrupt is enabled in
case it causes a crash
TESTED=IoTuz ESP32 board and original 328p arduino to make sure current
code did not break.
- disable a lot of defines not relevant to ESP32, set them to 1 (no-op)
- change default IR pin to 35 from 11
- changed serial speed to 115200 (9600 is too slow to keep up with IR input)
- irSend disables code that will not compile on ESP32. It won't work,
but it won't break compilation either.
Most work already done by zenwheel, but the sendPanasonic command
didn't work. Sending and decoding is confirmed to work with using both
the JVC and Panasonic protocol.
The library has also been updated to work with Arduino IDE 1.0.
